Elevator Display Board FAA26800CB1 for Otis

Descrição

Informações sobre o produto

Modelos relacionados e alternativos

Other Otis display boards, and the car station boards that sit behind the panel.

Otis display boards:

• FAA25100AA2 / FAA25100K1 — LCD car display
• FAA23600AB1 — arrival clock display
• DAA26800AS1 — LCD display board
• DBA26800CR1 / CR3 — landing call LCD display

Otis car station boards:

• DAA26800CB1 / CB2 / CA1 — communication board
• DBA26800J1 — communication address board

Potensi supplies the Otis elevator display board FAA26800CB1, the Otis elevator car display panel and the Otis display PCB board range behind it. The models above are only a part of what we can supply. We stock and source a much wider range of related and alternative models. If your model number is not listed here, please send us the model number or a photo of the original part, and we will confirm availability and the correct match for you.

Porquê escolher a Potensi?

• Cobertura de mercado do 99%: Podemos fornecer cerca de 99% de peças sobressalentes para elevadores disponíveis no mercado.
• Garantia de Qualidade Autêntica: Fornecemos componentes para elevadores originais e fiáveis.
• Apoio à identificação por peritos: Envie-nos o número do modelo ou fotografias do produto e poderemos ajudá-lo a identificar a peça correta.
• Envio internacional: Oferecemos um serviço de entrega internacional rápido e fiável para projetos de manutenção de elevadores.

Perguntas frequentes

Q1: What is the FAA26800CB1?

R: It is the all-in-one car display panel of an Otis car operating panel, the unit that shows floor position and travel direction to passengers. It is the complete display assembly, not a single small indicator. It sits behind the COP faceplate, so the passenger only sees the screen.

Q2: Is it a bare PCB or a complete panel?

R: It is supplied as the display assembly, with the screen and its board together. The same number family also contains separate boards, so the two are not the same item when you are ordering. Send us a photo of what you are removing and we will tell you which one you need.

Q3: What is the size, and does it matter?

R: This unit is the 7 inch (178 mm) version. The size must match the opening in your COP faceplate, and a smaller or larger unit will not sit in the same cut-out. Measure the visible screen area and the fixing centres on your panel before ordering.

Q4: Which Otis systems use this panel?

R: The public listings for this number do not name the systems it was built for, so we will not guess at them. What identifies it is the label on the unit, the size, and the connector at the back. Photos of all three are enough for us to match it to your lift.

Q5: The display is blank or flickering. Is the panel finished?

R: Check the supply to the panel and the ribbon or plug at the back first, since a loose connector gives the same symptom. Look for a dim backlight, a few missing segments or a screen that comes back when the COP is tapped, which point at the panel itself. If the supply is good and the screen stays dark, replace the unit rather than the whole COP.

Q6: What should I send before ordering?

R: A photo of the front and back of the old panel, with the label readable. A photo of the connector and the fixing points. The cut-out size of your COP faceplate, and the quantity you need.