説明
製品情報
関連モデルおよび代替モデル
Other IOC main board versions, and the TKE boards that are replaced with it.
IOC main board versions:
- IOC-2B — earlier main board
- IOC-3B Ver 2.1 — earlier version
- IOC-3B Ver 2.2C G02 — earlier version
- IOC-3B Ver 3.1D — later version
Other TKE boards replaced with it:
- CMBK — circuit board
- MC2 — main board
Potensi supplies the TKE elevator main board IOC-3B Ver 3.1C, the TKE elevator main control board and the TKE PCB board range that goes with it. The models above are only a part of what we can supply. We stock and source a much wider range of related and alternative models. If your model number is not listed here, please send us the model number or a photo of the original part, and we will confirm availability and the correct match for you.
ポテンシを選ぶ理由
- 99% の市場カバレッジ: 弊社では、市場で入手可能なエレベーター用スペアパーツを約99%分供給可能です。.
- 確かな品質保証: 当社は、純正で信頼性の高いエレベーター用部品を提供しています。.
- 専門家による身元確認の支援: 型番または製品の写真をお送りいただければ、適切な部品をご案内いたします。.
- 国際配送: 当社は、エレベーターの保守プロジェクトにおいて、迅速かつ確実な国際配送をサポートしています。.
よくある質問
Q1: What is the IOC-3B board?
A: It is the main control board of the controller on TKE lifts built in Korea, mounted inside the control cabinet. It is the board that runs the lift’s control logic, so everything else in the cabinet depends on it. When it fails, the car usually stops and the controller either shows fault codes or goes quiet.
Q2: Does the version number matter?
A: Yes, and it matters more than the base code. Ver 2.1, 2.2C, 3.0, 3.1C and 3.1D are all in circulation on the same board design. Fitting a different version can leave the lift running with functions that do not behave as the site expects. Read the version printed on your old board and order that one.
Q3: What is B666K001-3001?
A: It is the part code suppliers quote alongside the IOC-3B name for this board. The two appear together in listings, so either can be the number a buyer searches for. Send us both the code and the version from your old board, and we confirm the match.
Q4: Is it a replacement for the IOC-2B?
A: No. IOC-2B is the earlier main board of the same family and is quoted as a separate item. The two are not the same board, and the lift’s own marking decides which one it takes. If the old board reads IOC-2B, tell us and we quote that instead.
Q5: Does the board need programming after fitting?
A: The board carries the lift’s control software and settings, so this is not a part to fit blind. Tell us the version and any parameter record you hold for the site before ordering. We confirm what state the board is supplied in rather than promising that it runs as it arrives.
Q6: What should I send before ordering?
A: A photo of the old board, front and back, with the version and part code readable. A photo of the cabinet label showing the controller type and the lift’s data. The quantity you need, and whether you also need the CMBK board that is often changed with it.

