Elevator Door Hanger Roller AAA456YA2 for Otis

Descrição

Informações sobre o produto

Modelos relacionados e alternativos

Other Otis door rollers, in the same 85 mm size and in other sizes.

Same 85 mm Otis door rollers:

• AAA456YA1 — same size, other version
• AAA456YA4 — same size, other version
• DAA456N2 — 85×20, 6204Z bearing
• DAA456N1 — 85×20, 6204Z bearing

Otis door rollers in other sizes:

• 456EW1 — door hanger system roller
• CAA456B2 — 3 inch roller with shoulder
• 456CC1 — 2-3/4 inch hanger roller

Potensi supplies the Otis elevator door hanger roller AAA456YA2, the Otis elevator door roller and the Otis door hardware range that goes with it. The models above are only a part of what we can supply. We stock and source a much wider range of related and alternative models. If your model number is not listed here, please send us the model number or a photo of the original part, and we will confirm availability and the correct match for you.

Porquê escolher a Potensi?

• Cobertura de mercado do 99%: Podemos fornecer cerca de 99% de peças sobressalentes para elevadores disponíveis no mercado.
• Garantia de Qualidade Autêntica: Fornecemos componentes para elevadores originais e fiáveis.
• Apoio à identificação por peritos: Envie-nos o número do modelo ou fotografias do produto e poderemos ajudá-lo a identificar a peça correta.
• Envio internacional: Oferecemos um serviço de entrega internacional rápido e fiável para projetos de manutenção de elevadores.

Perguntas frequentes

Q1: Where is the AAA456YA2 roller fitted?

R: It is the hanger roller of an Otis landing or car door, the wheel that runs on the hanger track and carries the door panel. Two of them usually carry one panel, so a worn set is normally replaced together. It is a mechanical wear part, not a door operator component.

Q2: What does “eccentric” mean here?

R: The roller centre is offset from its mounting point instead of sitting on the axis. That offset is what lets the panel be brought up to the track and set level along its travel. A plain concentric roller of the same diameter will bolt on, but the door cannot be adjusted the same way.

Q3: Are AAA456YA1 and AAA456YA4 the same roller?

R: Distributors quote all three codes on the same 85 x 20 mm roller with a 6203 bearing. The suffix letters mark different versions of the same part, not different sizes. Send the code from your old roller and we confirm which one you are replacing.

Q4: Which bearing does it use?

R: The 6203RS bearing, the sealed type, as you specified. Some listings for this roller family quote a 6204 bearing; those are wider wheels with a larger bore and will not fit the same hanger. If the old wheel carries a 6202, the wheel you have is not this size, so tell us before ordering.

Q5: How do I know the roller is worn?

R: Listen for a rumble or a scraping sound as the door runs, and look for a flat spot on the tread. A worn roller also shows as the panel dragging at the start of travel, or a gap that changes along the track. Check the track and the guide gibs first, because a loose gib imitates a worn roller.

Q6: What should I send before ordering?

R: A photo of the old roller in place, so the hanger type is visible. The wheel diameter and width measured across the tread. The bearing number stamped on the seal, and the quantity you need per panel.